What is the opinion of Reddit about the
Fdit PTC Car Fan Air Heater for Small Room Space (12V 100W)?

A total of 2 reviews of this product on Reddit.

1 point

·

12th Feb 2022

I use the a 100w small heater with built in fan, and a thermostat with an old pc power supply.

Maintains temperature very well, I’ve done a few 10+hr print and just finished a 33.5hr print (Full Mono x height)
I put the heater on the side without the antenna, and put the temp probe taped to my resin vat near the screw on the far side. Maintains a constant 30c for Siraya Tech Blu printing. It takes about 15min to fully heat up.
I have some print quality issues, but not related to heat.
Heater: https://www.amazon.com/dp/B07B26KKH7/ref=cm_sw_r_tw_dp_FRREV1ACWW9XSDS102MN?_encoding=UTF8&psc=1

Thermostat:
https://www.amazon.com/gp/product/B07XDCB7B5/ref=ppx\_yo\_dt\_b\_search\_asin\_title?ie=UTF8&psc=1

1 point

·

20th Aug 2021

Just a quick Amazon search came up with these:

12 volt heater
control module

battery charger